Click For Large Image3 pcs Nema17 Stepper Motor single with 53.8oz-in holding torque
3 PCS Stepper Driver with 1.7A DQ420MA replacing M415
1 pc power supply for 100W,24VDC
1 PC DB25 Breakout Board & 1 Cable for free offering
Technical Specifications:
1.Stepper motor
Part No.: 42BYGH801
Step Angle : 1.8 degree
Voltage : 12V
Current: 0.4A
Resistance : 30mh/phase
Holding torque : 38N.cm / 53.8OZ-IN
Rotor inertia: 68g-cm2
Detent torque: 280g-cm
Number of wire leads: 6
Length: 48mm
2.stepper motor driver
DQ420MA stepper motor driver with 1.7A peak current,12-36VDC ,128 Microstep，replacing M415B
Introduction:
DQ420MA is a type of two-phase hybrid stepping motor driver, the drive voltage of which is from 12VDC to 36VDC. It is designed for use with 2-phase hybrid stepper motor of all kinds with 20mm to 42mm outside diameter and less than 2.0A phase current. This circuit that it adopts is similar to the circuit of servo control which enables the motor to run smoothly almost without noise and vibration. Holding torque when DQ420MA driver runs at high speed is also significantly higher than other two-phase drivers, what’s more, the positioning accuracy is also higher. It is widely used in middle and big size numerical control devices such as curving machine, CNC machine, and computer embroider machine, packing machines and so on.
Features:
1. High performance, low price
2. Average current control, 2-phase sinusoidal output current drive
3. Supply voltage from 12VDC to 36VDC
4. Opto-isolated signal I/O
5. Over-voltage, under voltage, over-current, phase short circuit protection
6. 8 channels subdivision and automatic idle-current reduction
7. 8 channels output phase current setting
8. Offline command input terminal
9. Motor torque is related to speed, but not related to step/revolution
10. High start speed
11. High holding torque at high speed
1.Electrical specification:
|
Input voltage |
12-36VDC |
|
Input current |
＜ 2A |
|
Output current |
0.44A- 2.83A |
|
Consumption |
Consumption：40W； |
|
Temperature |
Working Temperature -10～45℃； Stocking Temperature -40℃～70℃ |
|
Humidity |
No condensation, no water droplets |
|
gas |
Prohibition of combustible gases and conductive dust |
|
weight |
70G |
3.Breakout board
1) Built in DB25 male connector.
2) DB25 Output Pin:P1,P2,P3,P4,P5,P6,P7,P8,P9,P14,P16,P17.
3) DB25 Input Pin: P10,P11,P12,P13,P15.
4) DB25 GND Pin: P18-P25.
5) Power supply: +5V DC.
6) Built in C-class Optical-coupler.
7) High quality with Surface-mount Tech.