3 PCS stepper motor 85BYGH450C-012
3 PCS stepper driver DQ860MA
3PCS Power Supply 350W-60V
1 PC Breakout board & Cable & software Mash 3
1, Stepper Motor
Specifications of 85BYGH450C-012 unit=mm
Part No.: 85BYGH450C-012
Step Angle: 1.8 degree
Voltage: 6.3VDC
Current: 3.5 A/phase
Resistance: 1.8Ohm/phase
Inductance: 21mH/phase
Holding torque: 11.5N.m 1628.4oz-in
Rotor inertia: 3600 g-cm2
Detent torque: 24.5 kg-cm
Number of wire leads: 4
Weight: 5KG
Length: 151mm
2.stepper motor driver
Features:
1) High performance, low price
2) Average current control, 2-phase sinusoidal output current drive
3) Supply voltage from 24VDC to 80VDC
4) Opto-isolated signal I/O
5) Overvoltage, under voltage, overcorrect, phase short circuit protection
6) 14 channels subdivision and automatic idle-current reduction
7) 8 channels output phase current setting
8) Offline command input terminal
9) Motor torque is related with speed, but not related with step/revolution
10)High start speed
11)High hording torque under high speed
1.Electrical specification:
Input voltage |
24-80VDC |
Input current |
< 6A |
Output current |
2.8A~7.8A |
Consumption |
Consumption:80W; Internal Insurance:10A |
Temperature |
Working Temperature -10~45℃; Stocking temperature -40℃~70℃ |
Humidity |
Not condensation, no water droplets |
gas |
Prohibition of combustible gases and conductive dust |
weight |
500g |
3. power supply
3 PCS Power Supply 350W-60V
4.Breakout board
De
- Built in DB25 male connector.
- DB25 Output Pin:P1,P2,P3,P4,P5,P6,P7,P8,P9,P14,P16,P17.
- DB25 Input Pin: P10,P11,P12,P13,P15.
- DB25 GND Pin: P18-P25.
- Power supply: +5V DC.
- Built in C-class Optical-coupler.
- High quality with Surface-mount Tech.